Quick MDT 2012 facts
I’ve been quite busy lately so I’ll try to be quick… I would like to share my discoveries on MDT 2012 and the information I gathered while I was migrating from MDT 2010.
- Mikael Nystrom’s step by step on how to update BIOS in MDT still works perfectly.
- Andrew Barnes’ how to integrate BGInfo into WinPE still works, and even better, MDT 2012 comes with a 64-bit version of BGInfo (located at %deploymentshare%\Tools\x64).
- It is no longer needed to have a custom pane to set local administrators in MDT 2012. Instead use the “SkipAdminAccounts=NO” property in CustomSettings.ini. Please note that the administrators accounts page only appears if you selected “Join a domain” as I mention on the TechNet Forums.
- Thanks to Michael Niehaus, DaRT integration is now fully supported in MDT 2012. I talked about this earlier but it’s always good to reiterate the benefits of software assurance.
- A very interesting new feature of MDT 2012 is monitoring. It can be enabled in a few simple steps: Navigate to your deployment share properties, go to the last tab called “Monitoring”, check the box called “Enable monitoring for this deployment share”. Then click OK. It should work right away… A good way to check is to look at your CustomSettings.ini for a new line called “EventService=http://myserver.corp/contoso.com“. Is you run into issues there is always this good troubleshooting article. Used in conjonction with DaRT, you can remotely control deployments from a central location.
- Another feature that might not be actually that new but still useful is the “SLSHARE=” property. It allows you to set a network share where the logs are written during the deployment. This is particularly useful when your helpdesk people forget to capture logs if a deployment fails. A good security practice it to set a sticky bit, using the user directory technique on that particular folder since logs may contain sensitive information.
- You are now able to use only one (32-bit) boot image to initiate both 32-bit and 64-bit deployments. A word of caution, though, if you need to use DaRT to repair an install you will need to boot the appropriate architecture.